Replace Laurastar Water Tank on Lift & IZZI Plus

Quick answer

Replacing the water tank on your Laurastar Lift or IZZI Plus is a simple process: unplug the iron, remove the empty tank, insert the new Laurastar Water Tank (Complete), and lock it in place. Always use a genuine Laurastar tank to avoid leaks or damage.

Step-by-step replacement guide

1. Unplug and cool down: Turn off and unplug your Laurastar ironing system. Allow it to cool completely before handling the water tank. Hot water can cause burns. Never attempt replacement while the system is hot or plugged in.
2. Remove the empty tank: Press the release button (usually located on the top or side of the tank) and gently pull the tank upward and out. If it sticks, do not force it; check that the system is fully cool. If the tank is stuck, verify the system is off and cool—do not use tools to pry it out.
3. Prepare the new tank: Remove the new Laurastar Water Tank from its packaging. Inspect it for any cracks or debris. Rinse it with clean water if desired. Check the tank's seal and condition before installing.
4. Insert and lock the new tank: Align the new tank with the slot on the ironing system. Lower it into place until you hear a click. Tug gently to confirm it is locked. A proper click and secure fit prevent leaks during use.
5. Test the system: Plug in the system, fill the tank with water (if not pre-filled), and run a short steam cycle. Check for leaks around the tank connection. If you see or hear leaks, repeat step 4 to ensure a proper lock.

Product facts

• Laurastar Water Tank - Complete (For Models: Lift / IZZI Plus): This water tank is compatible with Laurastar Lift and IZZI Plus models. It includes the complete tank assembly for easy swap-out. Using the correct tank ensures a secure fit and reliable steam performance, preventing leaks and potential damage to your ironing system.